06.07.17
Springfield Solutions, based in Hull, UK, has installed a vacuum waste handling system from Matho. The target of the system is to capture, cut and extract eight edge trims from four finishing lines into a 1,000l big bag.
The installed Cuttobag CB-1000.1 is equipped with 2x Cuttopipe CM-160 inline cutting systems, complete piping system, transportation fan (frequency controlled) and material separator. As the customer runs a lot of film material, an anti-static-system was installed inside the material separator to avoid blockages inside the unit.
To recover the heated or cooled air, an air-return-system was also installed by the Matho technicians. As part of its 1.3 million GBP #PrintWorks expansion, the system is intended to handle the production increase of 30%.
After three years of continuous growth, this building and its production capabilities enlargement was deemed necessary. According to Steve Nix, print operations manager, the company is very happy about the project planning and installation, as well as the operating results of the complete system.
The installed Cuttobag CB-1000.1 is equipped with 2x Cuttopipe CM-160 inline cutting systems, complete piping system, transportation fan (frequency controlled) and material separator. As the customer runs a lot of film material, an anti-static-system was installed inside the material separator to avoid blockages inside the unit.
To recover the heated or cooled air, an air-return-system was also installed by the Matho technicians. As part of its 1.3 million GBP #PrintWorks expansion, the system is intended to handle the production increase of 30%.
After three years of continuous growth, this building and its production capabilities enlargement was deemed necessary. According to Steve Nix, print operations manager, the company is very happy about the project planning and installation, as well as the operating results of the complete system.